Description
- Forged saddles include size, USA and CM logo
- Drop-forged base for superior function and toughness
- Galvanized finish
- Dead end wire rope tail length should be at least
6 rope diameters, but not less than 6 inches beyond
the wedge socket. - Apply U-bolt and first saddle on dead end rope and
the second saddle on live end rope. Install nuts. - Position the dual saddle clip so that 3 to 4 inches
of dead end rope remain beyond the clip. - Tighten nuts evenly. Alternate tightening each
nut until reaching the required torque specified. - Check that clip does not pinch or clamp the
live wire rope. Apply an initial test load equal to
the loads expected in regular use. Be certain rope
is secured properly in the wedge socket prior to
any use. - Inspect for proper rope alignment with wedge socket
and retighten the nuts to the specified torque
Reviews
There are no reviews yet.